Logo

Stuff you'll need


Acrylic sheets

You will need a lot of 3mm and some 1mm sheets of A4 acrylic. I buy mine on ebay from Wholesale POS. I buy A4 as that's the maximum size that fits into the K40 laser cutter and two 3mm works out very close to the real panel heigh if you use two. You need two as often the lower layer has smaller cutouts to allow switches to be attached.
You only need the saw cut sheets as you don't need the edges anyway.

You will also need some 3mm and 1mm clear for the glass in some dials/gauges,


Switches

The Tornado has a lot of switches so you will need a metric butt load of various kinds. In the build instruction I'll list what you need for each panel. I usually buy these in batches of at least ten at a time, especially as the cheapest are usually from China. I get these from eBay as well but I'm not fussy who they come from as they're all the same.
You need to be careful to check if a switch is a toggle or momentary or even both. The ast majority are just plain on/off toggle switches.


LEDs

I've bought hundreds of LEDs. You'll need 3mm 5v in red, green, white and yellow. Again I get these from eBay.


Cable

I use white cable for most of the wiring but use red and black to indicate +5V and GRN.


Screws

I have so many kinds of screws now that locating the ones I need is getting difficult. Again, I buy these in bulk as you never know when you need one. I will at some point update this page to show what screws you need and for what as I will have a pretty good idea of what I've ordered over the years.


Springs

Most of the 3D printed switches need a spring.